Test the hand brakes to make sure that they work correctly for both the front and back tire. You should have two light reflectors, two pedals, the bike seat and post, as well as the quick release lever to adjust the seat, some of these items are located in a small cardboard box that comes with the set. First, slide the front reflector light onto the handlebars and tighten it up using your Philips head screwdriver. Proceed to slide the handlebars onto the bike’s body, it should slide down without any problems. If it gets stuck, adjust the rotating screw at the bottom of the handlebar so that it aligns correctly with the bike’s body and slide it in place. Do both the screw that connects to the body and the other top screw at the top of the handlebars.
The seat post simply slides in place, but first you should slide the light reflector on it and screw it in place. There should be a back quick release clamp that will hold the seat in place that attaches to the seat post, simply grab hold of the lever, clamp it down, and pull it tight to hold the bike seat in place. The basic rule of thumb is that the bike seat should be almost equal to the height of your waist, adjust hyper bike the seat accordingly so that it is comfortable. Adjust the front brake pads by pulling the silver wire tight and holding it in place, then tighten the screw back up- You may need an extra pair of hands to do it correctly. You can tighten the tire’s nuts and the front brake’s cap by using an adjustable wrench. It loses three points for the small defects and bad customer service from the manufacturer and seller.
This will be the lowest possible rate until you are logged in and enter your delivery address. Once we know your delivery address, the estimated cost will change to a final delivery cost in the order summary. The delivery fee for your order depends on the type of product you are purchasing (in particular, the size and weight of a product). By taking innovation to the next level and creating the world’s best tires,we’re on that journey too.
The bike gears and peddles are slightly stiff, but I am sure it will loosen up with a bit of oiling and riding. I would recommend this bike if you are on a budget and need basic transportation for getting around because it does the job and serves its purpose. As far as cheap mountain bikes go, overall the Havoc Hyper FS mountain hyper bike bike isn’t really all that bad. Use your 5mm hex key to adjust the screw at the top of the brake levers to rotate them around and set them in place. If your handlebars are on backwards this screw will be at the bottom of the brake lever. Make sure that they are comfortable and your wrists are not straining to use them.
It is an aluminum frame and the tag that was attached to the bike says that it can hold about 275 lbs or so. I was a bit surprised by this because the manufacturer should have sent us the part since the bike was just ordered brand new and we had the order number and receipt. For a product that would have cost the company a minimum of $10 to ship out, I did find it a bit frustrating that their customer service was so poor and we ended up having to pay for the replacement ourselves. The next problem is that the bike seat is hard and uncomfortable, if you only ride short distances it isn’t a problem, but if you do between 2 through 5 miles you will start to feel it. The handlebars sometimes wobble and slide out-of-place, not at the base where it connects to the body, but literally at the center “T” joint at the top near where your hands are, it will slip out-of-place and slide around. I have tightened it a few times and it now finally stays in place, but it can be dangerous when it randomly slides over while riding.